Beaucoup de travailleurs espèrent obtenir quelques Certificat IT pour avoir une plus grande space de s'améliorer. Certains certificats peut vous aider à réaliser ce rêve. Le test Cisco 100-101 est un certificat comme ça. Mais il est difficile à réussir. Il y a plusieurs façons pour se préparer, vous pouvez dépenser plein de temps et d'effort, ou vous pouvez choisir une bonne formation en Internet. Pass4Test est un bon fournisseur de l'outil formation de vous aider à atteindre votre but. Selons vos connaissances à propos de Pass4Test, vous allez faire un bon choix de votre formation.
Le test simulation offert par Pass4Test est bien proche du test réel. Vous pouvez apprendre tous essences d'un test réel à courte terme avec l'aide de Pass4Test. Pass4Test peut vous assurer le succès 100% de test Cisco 100-101.
Code d'Examen: 100-101
Nom d'Examen: Cisco (CCNA Interconnecting Cisco Networking Devices 1 (ICND1))
Questions et réponses: 102 Q&As
Finalement, la Q&A Cisco 100-101 plus nouvelle est lancé avec tous efforts des experts de Pass4Test. Aujourd'hui, dans l'Industrie de IT, si on veut se renforcer sa place, il faut se preuve la professionnalité aux les autres. Le test Cisco 100-101 est une bonne examination des connaissances professionnelles. Avec le passport de la Certification Cisco, vous aurez un meilleur salaire et une plus grande space à se développer.
On doit faire un bon choix pour passer le test Cisco 100-101. C'est une bonne affaire à choisir la Q&A de Pass4Test comme le guide d'étude, parce que vous allez obtenir la Certification Cisco 100-101 en dépensant d'un petit invertissement. D'ailleur, la mise à jour gratuite pendant un an est aussi gratuite pour vous. C'est vraiment un bon choix.
100-101 Démo gratuit à télécharger: http://www.pass4test.fr/100-101.html
NO.1 Refer to the exhibit.
If host A sends an IP packet to host B, what will the source physical address be in the frame when it
reaches host B?
A. 10.168.10.99
B. 10.168.11.88
C. A1:A1:A1:A1:A1:A1
D. B2:B2:B2:B2:B2:B2
E. C3:C3:C3:C3:C3:C3
F. D4:D4:D4:D4:D4:D4
Answer: E
Cisco examen 100-101 100-101
Explanation:
When packets transfer from one host to another across a routed segment, the source IP address
always remains the same source IP address, and the source physical (MAC) address will be the
existing router's interface address. Similarly, the destination IP address always remains the same
and the destination physical (MAC) address is the destination router's interface address.
NO.2 Which OSI layer header contains the address of a destination host that is on another network?
A. application
B. session
C. transport
D. network
E. data link
F. physical
Answer: D
Cisco 100-101 examen 100-101 100-101 100-101
Explanation:
Only network address contains this information. To transmit the packets the sender uses network
address and datalink address. But the layer 2 address represents just the address of the next hop
device on the way to the sender. It is changed on each hop. Network address remains the same.
NO.3 Which layer of the TCP/IP stack combines the OSI model physical and data link layers?
A. Internet layer
B. transport layer
C. application layer
D. network access layer
Answer: D
Cisco examen 100-101 certification 100-101 certification 100-101
Explanation:
The Internet Protocol Suite, TCP/IP , is a suite of protocols used for communication over the internet.
The TCP/IP model was created after the OSI 7 layer model for two major reasons. First, the
foundation of the Internet was built using the TCP/IP suite and through the spread of the World
Wide Web and Internet, TCP/IP has been preferred. Second, a project researched by the
Department of Defense (DOD) consisted of creating the TCP/IP protocols. The DOD's goal was to
bring international standards which could not be met by the OSI model. Since the DOD was the
largest software consumer and they preferred the TCP/IP suite, most vendors used this model rather
then the OSI. Below is a side by side comparison of the TCP/IP and OSI models.
TCP/IP Model VS. OSI Model Application Layer 7 Application Layer 6 Presentation Layer 5 Session
Transport Layer 4 Transport Internet Layer 3 Network Network Access Layer 2 Data Link Layer 1
Physical
NO.4 Refer to the exhibit.
If the hubs in the graphic were replaced by switches, what would be virtually eliminated?
A. broadcast domains
B. repeater domains
C. Ethernet collisions
D. signal amplification
E. Ethernet broadcasts
Answer: C
certification Cisco 100-101 100-101
Explanation:
Modern wired networks use a network switch to eliminate collisions. By connecting each device
directly to a port on the switch, either each port on a switch becomes its own collision domain (in
the case of half duplex links) or the possibility of collisions is eliminated entirely in the case of full
duplex links.
NO.5 Refer to the exhibit.
The host in Kiev sends a request for an HTML document to the server in Minsk. What will be the
source IP address of the packet as it leaves the Kiev router?
A. 10.1.0.1
B. 10.1.0.5
C. 10.1.0.6
D. 10.1.0.14
E. 10.1.1.16
F. 10.1.2.8
Answer: E
Cisco 100-101 examen 100-101 examen
Explanation:
Although the source and destination MAC address will change as a packet traverses a network, the
source and destination IP address will not unless network address translation (NAT) is being done,
which is not the case here.
NO.6 Which three statements are true about the operation of a full-duplex Ethernet network?
(Choose three.)
A. There are no collisions in full-duplex mode.
B. A dedicated switch port is required for each full-duplex node.
C. Ethernet hub ports are preconfigured for full-duplex mode.
D. In a full-duplex environment, the host network card must check for the availability of the network
media before transmitting.
E. The host network card and the switch port must be capable of operating in full-duplex mode.
Answer: A,B,E
certification Cisco certification 100-101 100-101 examen 100-101 100-101 examen
NO.7 Which protocol uses a connection-oriented service to deliver files between end systems?
A. TFTP
B. DNS
C. FTP
D. SNMP
E. RIP
Answer: C
Cisco examen certification 100-101 100-101 examen 100-101
Explanation:
FTP is an acronym for File Transfer Protocol. As the name suggests, FTP is used to transfer files
between computers on a network. You can use FTP to exchange files between computer accounts,
transfer files between an account and a desktop computer, or access online software archives
NO.8 Refer to the exhibit.
HostX is transferring a file to the FTP server. Point A represents the frame as it goes toward the
Toronto router. What will the Layer 2 destination address be at this point?
A. abcd.1123.0045
B. 192.168.7.17
C. aabb.5555.2222
D. 192.168.1.1
E. abcd.2246.0035
Answer: E
certification Cisco 100-101 examen 100-101 examen certification 100-101
Explanation:
For packets destined to a host on another IP network, the destination MAC address will be the LAN
interface of the router. Since the FTP server lies on a different network, the host will know to send
the frame to its default gateway, which is Toronto.
Quand vous hésitez même à choisir Pass4Test, le démo gratuit dans le site Pass4Test est disponible pour vous à essayer avant d'acheter. Nos démos vous feront confiant à choisir Pass4Test. Pass4Test est votre meilleur choix à passer l'examen de Certification Cisco 100-101, et aussi une meilleure assurance du succès du test 100-101. Vous choisissez Pass4Test, vous choisissez le succès.
没有评论:
发表评论